With the Moller you have your choice of:

• Stunning clean sound with just a little dirt around the edges.
• Solid overdrive with a hint of clean sparkle to make your distorted chords stand out
• Fire-breathing distortion with just a bit of clean signal for better definition

The MØLLER is a classic overdrive pedal that provides a wealth of dynamic overdriven tones with superb tonal control, as well as separate transparent 0-20 db adjustable and switchable clean boost, and a unique overdrive/clean mix option.

The mix knob lets you dial in the perfect balance between distorted and non-distorted signal.

Rolled all the way up and with distortion maxed too, the pedal sounds just like an old tube amp on full volume.

Roll the mix knob back a bit, and your clean signal starts to get through, meaning that if you pick lightly, or roll back the volume on your guitar, you get a stunning clean/softly clipping sound that retains all the feel and dynamics of your original tone, only bigger, louder and richer.

The boost function lets you dial in a solo level, whether the overdrive circuit is activated or not.

Features

• TONE, GAIN, MIX, BOOST and LEVEL, VOICE button, 2 switches (On/Off and Boost On/Off), 2 jacks (signal input/output), 9-12 volt DC input 2mm pin, 9 volt battery trunk, mint green.
• TONE: Adjusts the flavor of overdrive
• GAIN: Controls the amount of overdrive. This pedal has lots of body, even with Gain turned down.
• MIX: Blends distorted (wet) and non-distorted (dry) signal
• BOOST: Determines the amount of boost, from 1 - 20 db
• LEVEL: Adjusts the output volume
• VOICE: This pedal is tuned to fit all types of pickups, from Humbucker to single coil. Hit the VOICE button and hear the difference.

History

The Møller was developed 2 years ago for the Danish guitarist, Knud Møller. He plays guitar for Johnny Madsen and has also made a solo album. He needed a tube screamer with a separate boost. At that time, T-Rex produced a small number of units for other guitar players.

Demand increased a short while ago, so T-Rex made some refinements to the prototype and added the Moller to the T-Rex line.

Approximate Dimensions: 4" wide x 4.75" deep x 1.5" high

T-Rex pedals are handcrafted in Denmark.

Features True Bypass Switching.