|
The
Godlyke Power Pump is an inline voltage step-up converter that accepts 9 volts DC and
increases it to an output voltage of 12, 18, or 24 volts DC at specific current values
(see chart below). Output voltage is determined by position of the 3-way switch located
on the unit’s chassis. Input is standard polarity Tip positive/Barrel negative female
barrel connector and Output is standard polarity Tip negative/Barrel positive male
barrel connector.
Specifications:
- In: 9 VDC @ 1700 mA (recommended)
- Out: 12 VDC (.65 A) - 18 VDC (.44A) -
- 24 VDC (.33 A) @ 5%
- Power Rating: 7.83 W continuous
- Polarity: Tip Negative/Barrel Positive
Directions for Use:
Attach the PP-9 directly to the PA-9 or to a lead on the Cable-5 Daisy Chain Set the
PP-9 to the required voltage – It can only supply 1 voltage at a time.
Make sure you check the polarity and voltage of the unit to be powered before
connecting it to the Power Pump. Connect the PP-9 to the unit (s) to be powered - You
can power multiple units off each PP-9 as long as you do not exceed the max Current per
voltage listed above.
You can power up to 2 PP-9’s off one PA-9
Notes to User:
The Power Pump is designed to work in conjunction with the Godlyke PA-9 Power-All
9-volt digital power supply ONLY. Using it with other power supplies can damage them,
the PP-9, and/or the unit (s) being powered. Godlyke, Inc. assumes no responsibility for
damage resulting from abuse of misuse of this product. MAKE SURE TO CHECK THE VOLTAGE
AND POLARITY BEFORE CONNECTING ANY UNIT TO THE PP-9!!!
Power-Pump is a registered trademark of Godlyke, Inc.
Patents Applied For
Specifications subject to change without
notice.
|
review cart
Temporarily out of stock