Crate BX25DLX 25-Watt Bass Amp

248 Rock Hill Drive, P.O. Box 760
Rock Hill, NY 12775
Phone/Fax 845-796-3616

Crate BX25DLX
25-Watt Bass Amp

Pprovides solid bass tone along with innovative features. Players can conveniently tune their instrument with the BX25DLX top mounted chromatic tuner. Plus, along with the BX series superior sound players can dial in an octave effect, or switch between clean and distortion channels. The BX25DLX features a Crate 10" speaker, 25 watts RMS, limiter, and a headphone jack, which mutes the speaker.

Player Type: This is a perfect amp for home recording, practice, small jams and smaller live performances. Note: Unique top mount tuner.

$239.99
Includes UPS Ground Shipping
in Continental U.S.
Buy Now

Features:
Output Power Rating:	27 watts RMS @ 1% THD, 4 ohms 120 VAC
Gain:	50dB 0dB Input, 35dB -15dB Input, tones @ 5 @ 1kHz
Maximum Signal Accepted:	15 volts peak to peak
Input Impedance:	220k ohms
Signal to Noise:	75dB
EQs:	Low 28dB range @ 60Hz; Low Mid 15dB range @ 400Hz; High Mid 18dB range @ 1kHz; High 33dB range @ 10kHz
Speaker Size and Rating:	(1) Crate Custom 10", 30 watts, 4 ohms
Power Requirements:	120VAC, 60Hz, 45VA; 110/115VAC, 50/60Hz, 45VA; 230VAC, 50/60Hz, 45VA
Size and Weight:	17"H x 15.75"W x 12"D, 39 lbs
Specifications subject to change without notice.

Crate Tuner

1.	Input Plug your instrument's output cord in here.
2.	-15dB/0dB Switch This siwtch pads the imput signal 15dB when pressed in, allowing the use of hotter inputs such as tape decks or active basses
3.	Gain Set the input gain level for the corresponding input jack with these controls. The gain controls set the signal level going to the amplifier and serve as volume controls.
4.	Peak LED This indicator LED will light when the input signal is near the limits of the amp's input stages. Adjust the gain control (#4) so this LED flashes ocassionally.
5.	Contour Active When this pushbutton switch is pressed in the Contour Shape control is activated and the sound of your bass is affected by the setting of the control. Pressing the switch in a second time releases it, deactivating the Shape control.
7.	Graphic Equalizer Seven bands of frequencies from 50Hz to 5kHz may be boosted by moving the sliders up or cut by moving the sliders down. The lower frequencies are to the left and the higher frequencies are to the right. A great many tone variations are possible using different settings of these sliders.
8.	Master Level Control Use this control to set the output level of the amplifier. This controls the signal level at the Speaker Output jacks, as well as the Preamp Out jack.
9.	Limit Indicator LED A power amp limiter which automatically limits the signal to the power amp to a point just below ÒclippingÓ or distortion. This is to assure a clean undistorted sound at full power. The limit LED indicator will be lit whenever full power is reached.
10.	Balanced Line Out Level Control Adjusts the strength of the signal at the Balanced Line Output jack.
11.	Pre/Post EQ Switch Determines whether the line out signal is taken before (switch in) or after (switch out) the Gain, Shape, and Equalizer controls.
12.	Balanced Line Out Jack Provides a balanced output signal for connection to an external power amp, tape deck or mixing board.
13.	Send Jack This control adjusts the signal level at the Headphones jack.
14.	Return Jack Jack may be connected to the line level output of an external effects device. The 'Post Gain' configuration is helpful in obtaining optimum input signal levels to external devices and reducing the noise levels associated with them.
15.	Headphones For private practice sessions, plug a pair of stereo headphones into this jack. The internal speaker is disconnected whenever headphones are being used.
16.	External Speaker connect an extension speaker to the unit.
17.	On LED Glows when the amplifier is turned on.
18.	Power Switch This switch turns the amplifier on in the right position and off in the left position.
19.	Power Cord This heavy-duty, grounded, three-wire power cord is to be plugged into ONLY a safely-wired, grounded 120 volt, 60 cycle AC power outlet. DO NOT attempt to defeat the ground connection of this cable! If your amp was purchased outside of the United States, see the unit's rear panel for its power rating and follow the above guidelines.
20.	Fuse (rear panel, not shown) Protects the amplifier against damages caused from a faulty AC power source or other problems. If the fuse blows, replace it ONLY with the same size and type fuse. If the fuse blows repeatedly check the AC source; if it's okay, contact your Crate dealer for service information.

Prices quoted are subject to change. Quantities are limited on some items.
If you plan to order more than one of any item, please contact us before ordering to verify availability.
Click HERE for Return Policy. Questions? Call or e-mail steve@stevesmusiccenter.com.